Feb 26, 2021, 07:07 pm

News:

New, New TardisBuilders!


Master's TARDIS (Pillar)

Started by galacticprobe, Feb 20, 2016, 05:14 am

Previous topic - Next topic

elkad

I can't quite make out the numbers.... Dose it say feet or inches?  :-\

I was thinking the idea of making this tardis out of half cut cardboard roles & paper mache.
I looked for aluminum panels in my aria of town. Too expensive for my budget.

tony farrell

Quote from: elkad on Aug 26, 2019, 02:12 pm
I can't quite make out the numbers.... Dose it say feet or inches?  :-\


The dimensions are in millimeters.

T

Davros Skaro

Quote from: elkad on Aug 26, 2019, 02:12 pm
I was thinking the idea of making this tardis out of half cut cardboard roles & paper mache.
I looked for aluminum panels in my aria of town. Too expensive for my budget.


You making a model or full size one?
If full size try some corrugated sheeting, that might work & be cheaper. Just a thought.

Chris.
Chris.

Angelus Lupus

Aug 27, 2019, 10:03 am #18 Last Edit: Aug 27, 2019, 10:04 am by Angelus Lupus
I enhanced the plans a little, if that's of any help to anyone?
The Master's TARDIS exterior doric column edit.png
A mixed-up non-conformist, trying to fit in.

ciderman

I seem to remember there was a very good reference picture of the Masters TARDIS in the Peter Davison Dr Who annual. It may be on a PDF on a dvd?

elkad

Quote from: Davros Skaro on Aug 26, 2019, 11:54 pm
Quote from: elkad on Aug 26, 2019, 02:12 pm
I was thinking the idea of making this tardis out of half cut cardboard roles & paper mache.
I looked for aluminum panels in my aria of town. Too expensive for my budget.


You making a model or full size one?
If full size try some corrugated sheeting, that might work & be cheaper. Just a thought.

Chris.


That's the word I was looking for. I found some plastic corrugated sheeting, but still it would be cheaper to use paper mache. (full sizes, well half a full size, the half looking at the camera)