New, New TardisBuilders!
Started by warmcanofcoke, Feb 22, 2013, 06:49 pm
Quote from: warmcanofcoke on Feb 22, 2013, 10:59 pm...I'm having one of those moments where I realized something after the fact.The whole post is shown as 6.5" and the flat section is 4" - would make the actual moldings have a 2.5" diameter circle?
Quote from: galacticprobe on Feb 23, 2013, 06:09 amIf the post is 6.5 inches wide, and the "flat" is only 4 inches wide, then that would leave only 1.25 inches "sticking out" on either side of the flat to equal the 6.5-inch total width. So the question is, after placing the quarter-round moulding in to make that "corner", how much is left visible (the part indicated by the red arrow and circle)? Surely if we could figure out that part of the above plans then we would know what diameter circle the moulding would make, and then what size quarter-round should be used?Dino.