• Attn: If you were on the old forum, you may have to reset your password!

3D parts

senseidale

senseidale

Member
HI all, I have finally invested in a new 3D printer and i must say I am very happy thus far, I have printed  out NSD ear cages rear part of the eye stalk (printed out well but needs more detail, now moving on to gun parts they needed a bit of tweaking but Gcode files ready to go, the printer as i write printing out a pull to open Door sign.
IMG_5800.JPGIMG_5802.JPGIMG_5806.JPG back of eye stalk (not enough detail)
 
Hi all, this 3 D printing is time consuming, so far the printing has not let me down, I did use some old PLA that i had given to me, and it was rubbish so the PLA let me down, I was trying to print the "Pull to open .......  you know the rest  " in 3D Letters to replace the current  sign on  my Tardis door, I have now ordered Black  (both arriving today via Amazon) the will print the letters off I have also have been printing other stuff for the Dalek new eye parts gun parts some parts took 17 hours to complete, I have also have been printing other bits and bobs playing with slicing software. my daughter has ask for Handles from the Time of the DR, so will be getting on that Job asap.
Regards to all

fullsizeoutput_2274.jpegfullsizeoutput_2273.jpegfullsizeoutput_2272.jpegfullsizeoutput_2271.jpegfullsizeoutput_2275.jpegfullsizeoutput_2276.jpeg
 
Hi all been Printing more parts for Dalek upgrade but I did take a break and print Handles the Cyberman needs a sanding and then painting ( when I buy some paint) I know it’s not Dalek related but thought I would share 507FB4E5-E0C1-4CB8-ABE9-77541C256124.jpeg
 
You must log in or register to reply here.
Back
Top