i thought id give my own attempt at making whittaker plans based of my model which using the method of aligning my model with images of the box and tweaking and altering to get it as close to the box as i can get it , 1st attempt at plans for a box before if this helps anyone and turns out well id be more than happy to work on my skill and make more infuture , was unsure wether to post this in AWJ plans discussion if Mods feel it best to move this post by all means go for it would love to hear more from folk about it and i hope it helps peeps enjoy 

  Good looking plans! I'm having a go at modelling it now. Can I ask what the 17mm 14mm measurement is on the bottom left panel on the Side and Back elevation? Also, what height do you have for the outer edge of the chamfered panels? I'm assuming the 362mm measurement is for the inner part?

The 17 and 14 mm is the width of the angles that connect the panels to the walls the sloped part of the panels

Yup 362 mm is for the inside measurement of the panel 

And the outer height for the panels is basically 362 + 14 + 14 = 390mm if I'm not mistaken

Thank you for clearing that up. Much appreciated. 

here to help always happy to help out where i can