Success, I have the single servo moving randomly.   My question is for the 2nd servo as there is only room for 1 servo ground and 5 volt power.   How do I hookup the second servo at this point? 

Karst

Reverse the polarity. 

I found out from Dave,   second one goes in the 3.3v pin and the other GND and to then to pin 4.   I will be setting this up when I get home to test the code. 

Aha! I didn't even realise this was here, or at least I didn't remember this thread was here... anyway...


This is my attempt. Used a randomising code to move the pointer to different spots.